Professional Soluvar Gloss Varnish

Application

• Before varnishing ensure paint surface is fully dry - 72 hours-two weeks for acrylics, depending on thickness, and 6-12 months for oils
• Ensure your space is well ventilated and dirt and dust-free
• Place the artwork flat on a surface - always varnish horizontally
• Stir gently before use
• Can be thinned with up to 25% true mineral spirits
• Use a wide, flat soft-hair brush/pad/spray
• Apply 1-2 coats of Gloss Medium as a permanent isolating barrier first and leave to dry for three days
• Once completely dry, clean the surface with a lint-free rag dampened with mineral spirits
• Apply 1-2 layers of Soluvar, leaving 24 hours between coats
• Use long, even strokes, covering the surface top to bottom while moving from one side to the other - don't go over bits you have missed, but leave to dry and then re-varnish area
• While applying, look for surface bubbles and even them out immediately 

Removal

• Work in a clean, well-ventilated area
• Wear a dual filter respirator (NIOSH-approved) and neoprene gloves
• Use a small piece of soft, white, lint-free cloth dampened with true mineral spirits or turps. Lay the cloth on the surface for 15-30 minutes, checking to see if varnish is being dissolved. If it's taking longer, use a higher strength of the spirit and cover the area with plastic to slow down evaporation 
• After 15-30 minutes, rub the cloth over a small area 1-2 square inches until the Soluvar layer starts to dissolve
• Using a clean cloth and more solvent, rub the area again to remove residue
• Working horizontally, continue the same process for the entire area to be cleaned
• If any paint comes off on the cloth, stop immediately and move onto another area
• Once completed allow the surface to dry before reapplying a fresh coat of Soluvar